Edit this page

Localizing Edit Command Column

In order to localize the Edit/Update/Cancel buttons text you need to use the same-named properties as described below.

In-place edit (EditMode="InPlace")

In case of in-place editing, you need to set the following properties for GridEditCommandColumn:

  • EditText

  • UpdateText

  • InsertText

  • CancelText

<MasterTableView EditMode="InPlace">
  ...
  <Columns>
    ...
    <telerik:GridEditCommandColumn UniqueName="EditCommandColumn" CancelText="Cancel"
      UpdateText="Update" InsertText="Insert" EditText="Edit">
    </telerik:GridEditCommandColumn>
  </Columns>
</MasterTableView>

Edit in forms (EditMode="EditForms" or EditMode="PopUp")

In case of editing in forms, you need to set the following properties for EditColumn under MasterTableView.EditFormSettings:

  • UpdateText

  • InsertText

  • CancelText

<MasterTableView>
  <Columns>
    ...
    <telerik:GridEditCommandColumn UniqueName="EditCommandColumn" EditText="Edit">
    </telerik:GridEditCommandColumn>
  </Columns>
  ...
  <EditFormSettings>
    <EditColumn UniqueName="EditCommandColumn" CancelText="Cancel" UpdateText="Update"
      InsertText="Insert">
    </EditColumn>
  </EditFormSettings>
</MasterTableView>
note

When edit in forms is applied, MasterTableView . EditFormSettings can not be used for localizing the EditText property. Since the edit control is outside of the edit form you should set the GridEditCommandColumn.EditText property as demonstrated above.

Is this article helpful? No Yes
Thank you for your feedback!

Give article feedback

Tell us how we can improve this article

close
Dummy