Edit this page

SpellChecking Modes

RadSpellChecker allows you to choose between two spell-checking modes:

  • Check Word By Word

  • Check All Words At Once

Check Word By Word

To do this kind of check, you should set the SpellCheckMode property to WordByWord:

Setting SpellCheckMode.WordByWord

this.radSpellChecker1.SpellCheckMode = Telerik.WinControls.UI.SpellCheckMode.WordByWord;

Me.RadSpellChecker1.SpellCheckMode = Telerik.WinControls.UI.SpellCheckMode.WordByWord

When using this mode, RadSpellChecker will check every word in a separate window, which looks like this:

Figure 1: Spellchecking form in SpellCheckMode.WordByWord

spellchecker-spellchecking-modes 001

You are presented with a list of all possible suggestions, from which you can choose a word to replace the wrong one. Alternatively, you can ignore the word or add it to a custom dictionary.

note

This dialog will be called on every word considered wrong.

note

SpellCheckMode.WordByWord is the default value of the SpellCheckMode property so unless you have a complex scenario where you need to go from WordByWord to AllAtOnce and back, you do not need to set the property.

Check All Words at Once

To do this kind of check, you should set the SpellCheckMode property to AllAtOnce:

Setting SpellCheckMode.AllAtOnce

this.radSpellChecker1.SpellCheckMode = Telerik.WinControls.UI.SpellCheckMode.AllAtOnce;

Me.RadSpellChecker1.SpellCheckMode = Telerik.WinControls.UI.SpellCheckMode.AllAtOnce

When using SpellCheckMode.AllAtOnce, RadSpellChecker loads the entire content of the control being spell checked in a window looking like this:

Figure 2: Spellchecking form in SpellCheckMode.AllAtOnce

spellchecker-spellchecking-modes 002

You are presented with the same options as the WordByWord mode. The difference is that the entire spellchecking is executed in this window and only after that the content is transferred to the original control being spellchecked.